Modified values, Engine start – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 123
Tuning Guide
117
© 2014 AEM Performance Electronics
Modified Values
Calibration table changes that haven't been committed to flash memory are highlighted as shown
below. Conditions that will reset the display are as follows:
1. Manually committing changes through the Target > Commit modifications menu command
2. Manually committing changes using the hot key combination [Ctrl Shift C]
3. Opening and closing the Setup Wizard. Note the Setup Wizard automatically commits ALL
changes to memory every time it is closed.
4. Turning the ignition switch off when the tuning preference Key Off Commit is selected
Engine Start
There are several tables and options that affect starting the engine.
CrankVE_Table
Units: kPA vs RPM vs VE%
Description: This table sets the percentage of volumetric efficiency to be supplied to the engine
at various loads and engine speeds. This applies only while cranking the engine and does not
apply after the engine has reached idle speeds.