Apple Logic Pro X - Manual (Page 738)

Chapter 22 Surround in Logic Pro X 738
Use the Surround Panner on mono input channel strips
If the source input is set to mono, the Mono-to-Surround Panner appears. For more information,
see
Set the channel strip input format .
The graphical surround field at the top of the Mono-to-Surround Panner window controls the
surround routing of the input signal to speaker outputs. The level sliders and fields below the
surround field provide independent control of the Center and LFE channel levels. The extended
parameters allow you to precisely control the separation between channels.
m Use the parameters to change the diversity and angle, to change the output format, or to change
channel separation values.
Use the Surround Panner on stereo input channel strips
If the source input is set to stereo, the Stereo-to-Surround Panner appears. For more information,
see
Set the channel strip input format .
The Stereo-to-Surround Panner is similar to the Mono-to-Surround Panner, but features three pan
pucks: a puck for the L(eft) signal, a puck for the R(ight) signal, and a third puck, which controls
both the L and R pucks as a group. It also offers a Spread field in the upper-right corner, which
controls the stereo width of the signal.