Elkhart Brass Unibody Valve - Manual (Page 15)

15
800.346.0250 • www.elkhartbrass.com
2. Push the actuator assembly down against valve body assembly and rotate the assembly
in both directions slightly while pushing assembly against valve body until actuator drops
into slot in valve ball as shown in Figure 8. There should be no gap between the actuator
assembly and the valve body.
Figure 8
3. Rotate the actuator assembly on valve body until the rectangular actuator adapter aligns
with the square-mounting surface on the valve body. Ensure the rack is in the proper posi-
tion when the ball is open, as shown in Figure 9.
Figure 9
4. Fasten the actuator assembly to valve body assembly by tightening 5/16 socket head
cap screws in an X pattern to a torque of 15 ft-lb.
Rectangle adapter
aligns with valve
body adapter
No gap between
actuator assembly
and valve body
Ball in closed
position