Program id number (code 213) – Elkhart Brass Unibody Valve User Manual
Page 55
55
800.346.0250 • www.elkhartbrass.com
Program ID Number (Code 213)
Note: The red CLOSED LED must be flashing to change the program.
1. Use the OPEN button to set the first digit of code 213, two green LEDs on. Each time the OPEN button is
pressed the next green LED will go on.
Note: If an error is made when entering the code, continue to press the OPEN button until all 9
LEDs are on, press again and the LEDs will all be off, press to return to the first LED on.
2. Press the CLOSE button to move the cursor to the next digit. Now all LEDs will be off and ready for the
second digit to be entered. Press the OPEN button once, one green LED on.
3. Press the CLOSE button to move the cursor to the next digit. All LEDs will be off. Press the OPEN button
3 times, three green LEDs on.
4. After three seconds the ID is shown (factory default is 0). A maximum of 10 IDs can be set. Press the
OPEN button once and ID = 1 is selected.
5. Press the OPEN button 3 times and ID = 3 is selected.
6. Press the PRESET button for 3 seconds to exit. All LEDs will go off to indicate the data is accepted and the
control module return to normal operation after 2 seconds.
7. All LEDs will flash if there is a problem when exiting the programming mode. Press any button to
cancel the warning or let time out after 10 seconds.