Program id number (code 2130), Program flow display unit of measure (code 2150) – Elkhart Brass Unibody Valve User Manual

Page 57

Advertising
background image

57

800.346.0250 • www.elkhartbrass.com

Program ID Number (Code 2130)

1. Enter code 2130

– Press OPEN button 2 times to enter 2

– Press CLOSE button to move the cursor to the next digit

– Press OPEN button 1 time to enter 1

– Press CLOSE button to move the cursor to the next digit

– Press OPEN button 3 times to enter 3.

2. The pressure display will show 2130.
3. After 3 seconds the current ID number will show in the display.
4. Change the ID numbers as desired.

– Use the CLOSE button to select the digit to change. The digit will flash.

– Use the OPEN button to change the value of the flashing digit.

5. Press the PRESET button and hold for 5 seconds to exit and save the programmed parameters.

Program Pressure Display Unit of Measure (Code 2140)

There are three units of measure available for the pressure display:

PSI=PSI; PCAL=kPa; bAr=BAR.
1. Enter code 2140

– Press OPEN button 2 times to enter 2

– Press CLOSE button to move the cursor to the next digit

– Press OPEN button 1 time to enter 1

– Press CLOSE button to move the cursor to the next digit

– Press OPEN button 4 times to enter 4.

2. The pressure display will show 2140.
3. After 3 seconds the current unit of measure will show in the display.
4. Use the OPEN button to toggle the unit of measure.
5. Press the PRESET button and hold for 5 seconds to exit and save the programmed parameters.

Program Flow Display Unit of Measure (Code 2150)

There are two units of measure available for the flow display: gP=GPM; LP=LPM.
1. Enter code 2150

– Press OPEN button 2 times to enter 2

– Press CLOSE button to move the cursor to the next digit

– Press OPEN button 1 time to enter 1

– Press CLOSE button to move the cursor to the next digit

– Press OPEN button 5 times to enter 5.

2. The pressure display will show 2150.
3. After 3 seconds the current unit of measure will show in the display.
4. Use the OPEN button to toggle the unit of measure.
5. Press the PRESET button and hold for 5 seconds to exit and save the programmed parameters.

Advertising