Elkhart Brass Unibody Valve - Manual (Page 56)

56
ELKHART BRASS MANUFACTURING COMPANY, INC
XII. PROGRAMMING (UBEC2 AND UBEC3)
When in the program access mode the digital display will show operator inputs and program options.
To gain access to the program features a 4-digit program code must be entered.
Error Code E202
If error code E202 is shown it means that an invalid program code has been entered. Re-enter program code
when the digital display resets.
Programming Mode
Note: The valve must be closed and the red CLOSED LED must be on to program the valve
control. Press and hold the CLOSE button then press and hold the OPEN button. After 5
seconds the pressure display will show 4 dashes. The program code can now be entered.
Programming
When in the program access mode the digital display will show operator inputs and program options. To gain
access to the program features a four digit program code must be entered.
Error Code E202
If error code E202 is shown it means that an invalid program code has been entered. Re-enter program code
when the digital display resets.
Programming Mode
Note: The valve must be closed and the red CLOSED LED must be on to program the valve control.
Press and hold the CLOSE button then press and hold the OPEN button. After 5 seconds the pressure
display will show 4 dashes. The program code can now be entered.
Select Model Type (Code 2110)
The valve control and display module UBEC2 and can be programmed to act like a UBEC1; a UBEC3 can be
programmed to act like a UBEC2 or UBEC1.
Note: The pressure display must show four dashes to enter a program code.
1. Enter code 2120
– Press OPEN button 2 times to enter 2
– Press CLOSE button to move the cursor to the next digit
– Press OPEN button 1 time to enter 1
– Press CLOSE button to move the cursor to the next digit
– Press OPEN button 1 time to enter 1 .
2. The pressure display will show 2110.
3. After 3 seconds, the current programmed model type will show in the display.
4. Use the OPEN button to toggle the model type selection.
5. Press the PRESET button and hold for 5 seconds to exit and save the programmed parameters.
Program Primary or Remote (Code 2120)
1. Enter code 2120
– Press OPEN button 2 times to enter 2
– Press CLOSE button to move the cursor to the next digit
– Press OPEN button 1 time to enter 1
– Press CLOSE button to move the cursor to the next digit
– Press OPEN button 2 times to enter 2.
2. The pressure display will show 2120.
3. After 3 seconds the current selection will show in the display Pri or SLA.
4. Use the OPEN button to toggle the selection.
5. Press the PRESET button and hold for 5 seconds to exit and save the programmed parameters.