Elkhart Brass Unibody Valve - Manual (Page 49)

49
800.346.0250 • www.elkhartbrass.com
Figure 46. Weldment Installation
Pipe Size Dimension
(Sch 40) A
1.5 1.95 to 1.80
2 1.95 to 1.80
2.5 1.90 to 1.75
3 1.88 to 1.73
3.5 1.88 to 1.73
Note: When the retainer cap is
tightened make sure the sensor
rim flat spot does not disengage
from the alignment tab and allow
the flow sensor to rotate.
Note: Allow a minimum of 2 inches clearance
at the sensor top for removal/installation of
the connector.
Make sure that the alignment tab is
centered on the pipe centerline.
Note: These dimensions are typical
and are given to be used as an aid in
determining mounting locations for
flow sensors.
2.5"
2.8"
Retainer
Cap
Sensor
Housing
Weldment
O-Ring
Paddlewheel Flow
Sensor
Alignment Tab
Tru-Seal
Locknut
Alignment Tab
A
CL