Mounting the cornet, Mounting directly onto a wall – ElmoMC AC Input Digital Servo Drives-Bassoon Cable Kit User Manual
Page 19
Cornet Installation Guide
Installation
MAN-CORIG (Ver. 1.502)
19
1.12. Mounting the Cornet
The Cornet has been designed for two standard mounting options:
ccc.
Attaching directly to a wall with screws
ddd.
Mounting on a DIN rail
With either type of mounting, be sure to leave about 10 cm (4 in) above and below the
instrument for heat dissipation.
1.12.1. Mounting Directly onto a Wall
The vertical mounting strip at the back of the Cornet enables you to screw the drive directly
into a wall.
To mount the Cornet with the mounting strip:
1.
On the back of the drive, push the mounting strip up until it clicks and locks. The top lip
(with the hole) should be exposed.
Figure 3: Extending the Mounting Strip
Mount the Cornet vertically onto the wall with two screws, one through the top hole of the
mounting strip and one at the bottom.