ElmoMC AC Input Digital Servo Drives-Bassoon Cable Kit - Manual (Page 61)

Cornet Installation Guide Technical Specifications
MAN-CORIG (Ver. 1.502)
www.elmomc.com
61
1.20. Cornet Connections
The following connectors are used for wiring the Cornet.
Pins Type Maker & Part No. Port
5 Motor 8-Pole 8 mm pitch Molex terminal block M1, M2, M3
2 Ground PE, PE
3 Power AC1, AC2, AC3
2 Auxiliary Power 2 pole 0.325” (8 mm) pitch Molex terminal strip 24 V, 24 V RET
Connector Location
Table 16: Connectors on the Bottom of the Cornet
Pins Type Port Connector Location
8 RJ-45 COMM. 1
FEEDBACK B
FEEDBACK A
ANALOG INPUTS
COMMITTED I/O
COMM.2
GENERAL I/O
COMM.1
COR0001A
9 D-Sub Socket ANALOG INPUTS
8 RJ-45 COMM. 2
8 RJ-45
15 D-Sub Plug
High Density
COMMITTED I/O
15 D-Sub Socket
High Density
GENERAL I/O
15 D-Sub Socket FEEDBACK A
15 D-Sub Plug FEEDBACK B
Table 17: Connectors on the Cornet
CAN
FEEDBACK
A
FEEDBACK
B
RS-232
DIGITAL
OUTPUTS
ANALOG
INPUTS
DIGITAL
Auxiliary Power
Supply
Ground Motor Power