ElmoMC AC Input Digital Servo Drives-Bassoon Cable Kit - Manual (Page 49)

Cornet Installation Guide Installation
MAN-CORIG (Ver. 1.502)
www.elmomc.com
49
1.13.8.3. Digital Outputs (on the GENERAL I/O Port)
The Cornet servo drive has a 15-pin, high-density, D-Sub socket for digital outputs. When
assembling an I/O cable for digital outputs, follow the instructions in Section 1.13.4 (Feedback
and Control Cable Assemblies) using a 15-pin D-Sub plug with a metal case. The pins are
described below.
Pin Signal Function Pin Positions
1 OUT1 Programmable output 1
2 OUT2 Programmable output 2
3 OUT3 Programmable output 3
4 OUT4 Programmable output 4
5 OUT5 Programmable output 5
6 OUTRET1 Programmable output return 1
7 OUTRET2 Programmable output return 2
8 OUTRET3 Programmable output return 3
9 OUTRET4 Programmable output return 4
10 OUTRET5 Programmable output return 5
11 OUT6 Programmable output 6
12 OUTRET6 Programmable output return 6
13 - -
14 - -
15 - -
Table 13: Digital Outputs (on the General I/O port) Cable - Pin Assignments