ElmoMC AC Input Digital Servo Drives-Bassoon Cable Kit - Manual (Page 42)

Cornet Installation Guide Installation
MAN-CORIG (Ver. 1.502)
www.elmomc.com
42
1.13.7.4. Pulse-and-Direction Input Option on FEEDBACK B (YA[4]=0)
This mode is used for input of differential or single-ended pulse-and-direction position
commands on Port B1. In this mode Port B2 provides differential buffered pulse-and-direction
outputs for another axis.
Below are the signals on the Auxiliary Feedback ports when set up to run as a single-ended
pulse-and-direction input:
Port Pin Signal Function Pin Positions
- 1 N.C. Do not connect this pin
COR016A
15-Pin D-Sub Socket
B1 2 DIR/CHB Direction/Auxiliary Channel B high input
B1 3 PULS/CHA Pulse/Auxiliary Channel A high input
PWR 4 +5V Encoder supply voltage
PWR 5 SUPRET Encoder supply return
B2 6 CHAO Buffered Channel A output
B2 7 CHBO Buffered Channel B output
- 8 N.C. Do not connect this pin
- 9 N.C. Do not connect this pin
8
15
1
9
Port B1
Port B2
Power
N.C.
15-Pin D-Sub Plug
- 10 N.C. Do not connect this pin
- 11 N.C. Do not connect this pin
PWR 12 SUPRET Supply Return
B2 13 CHAO- Buffered Channel A complement output
B2 14 CHBO- Buffered Channel B complement output
- 15 N.C. Do not connect this pin
Table 9: Pulse-and-Direction Auxiliary Encoder Pin Assignment on FEEDBACK B
FEEDBACK B on the front of the Cornet has a 15-pin D-Sub plug. Connect the Auxiliary Feedback
cable from the Pulse and Direction Controller to FEEDBACK B using a 15-pin D-Sub socket with a
metal housing. When assembling the Auxiliary Feedback cable, follow the instructions in
Section 1.13.4 (Feedback and Control Cable Assemblies).