Powering up, Initializing the system, Powering up 1.15. initializing the system – ElmoMC AC Input Digital Servo Drives-Bassoon Cable Kit User Manual
Page 54
Advertising
Cornet Installation Guide
Installation
MAN-CORIG (Ver. 1.502)
54
1.14. Powering Up
After the Cornet has been mounted, check that the cables are intact. The Cornet servo drive is
then ready to be powered up.
Caution:
Before applying power, ensure that the AC supply is within the range specified
for your specific type of Cornet.
1.15. Initializing the System
After the Cornet has been connected and mounted, the system must be set up and initialized.
This is accomplished using the Composer, Elmo’s Windows-based software application. Install
the application and then perform setup and initialization according to the directions in the
Composer Software Manual.
Advertising