JULABO SE-Z Heating Circulators - Manual (Page 39)

HE / SE
39
Level 2 Level 3 Parameter level


•
Hours flash, set by pressing
+
•
Minutes flash, set by pressing
+

•
Day flashes, set by pressing
+
•
Month flashes, set by pressing
+

•
Year flashes, set by pressing
+

•
Return to factory settings by pressing
RESET returns all set values to the factory setting
except for date and time.

A RESET can be effected only in the –OFF- mode.

During the message –RUN- all parameters are
reset to factory settings.
9.4.1. Remote control via the serial interface
Factory setting: OFF The control electronics offer two ways of adjusting a setpoint.
1. Adjustment of setpoint using the keypad
or the integrated programmer.
2. Adjustment of setpoint via the serial interface RS232 using a PC or a
superordinated process control system.

The topline of the VFD-DISPLAY shows a bright „R“ for remote
control; - remote control discontinued.
RS232
IMPORTANT: additional measures for remote control

Connect the circulator to the PC using an interface cable.

Check the interface parameters of both interfaces (circulator and PC)
and make sure they match.
(refer to 12.1.
Setup for remote controll page 71)