JULABO SE-Z Heating Circulators - Manual (Page 4)

4
9.3. MENU PUMP - Setting of pump pressure ...............................................................37
9.4. MENU CONFIG - Configuration of unit ....................................................................38
9.4.1. Remote control via the serial interface ................................................................39
9.4.2. Keypad control or setpoint setting via the analog input .......................................40
9.4.3. AUTOSTART ......................................................................................................40
9.4.4. OFF-MODE ........................................................................................................41
9.4.5. ACTVAR - actuating variable ..............................................................................41
9.4.6. Setting of clock and date ....................................................................................42
9.4.7. RESET – Factory settings...................................................................................42
9.5. MENU CONTROL – Control characteristics and parameters...................................42
9.5.1. CONTROL – Control INTERNAL / EXTERNAL ...................................................44
9.5.2. SELFTUNING .....................................................................................................45
9.5.3. Dynamic internal .................................................................................................45
9.5.4. Control parameters– XP-, TN-, TV- INTERNAL ..................................................46
9.5.5. COSPEED - external ..........................................................................................47
9.5.6. Control parameters – XPU-, XP-, TN-, TV- EXTERNAL ......................................47
9.6. MENU SERIAL - BAUDRATE, HANDSHAKE, PARITY ...........................................48
9.7. MENU ATC - Absolut Temperature Calibration .......................................................49
9.7.1. ATC SENSOR - INTERNAL / EXTERNAL ..........................................................51
9.7.2. ATC STATUS - YES / NO ...................................................................................51
9.7.3. CALIBRATION TYPE: 1 -/ 2 -/ 3 POINT..............................................................52
9.7.4. Example: 3-point calibration for internal control .................................................53
9.8. MENU LIMITS - Begrenzungen ...............................................................................55
9.8.1. Limits for internal control .....................................................................................56
9.8.2. Limits for external control ....................................................................................56
9.9. MENU IN/OUT – Analog inputs/outputs (Option) .....................................................58
9.9.1. Outputs of the connector - REG+E-PROG ..........................................................61
9.9.2. Input of the connector - REG+E-PROG ..............................................................62
9.9.3. ALARM-output / Stand-by-input ..........................................................................64
10. Troubleshooting guide / error messages ......................................................................66
11. Electrical connections ..................................................................................................69
12. Remote control ............................................................................................................71
12.1. Setup for remote control ..........................................................................................71
12.2. Communication with a PC or a superordinated data system ...................................71
12.3. List of commands ....................................................................................................72
12.4. Status messages ....................................................................................................75
12.5. Error messages .......................................................................................................75
13. Installation of electronic module ...................................................................................76
14. JULABO Service – Online remote diagnosis ................................................................77
15. Cleaning / repairing the unit .........................................................................................78