Leica Biosystems IPC - Manual (Page 34)

32 Instructions for Use V 1.9 RevD – 05/2013
• If taped cassettes are used, make sure the
newly inserted stack aligns perfectly with the
previously loaded cassettes ( Fig. 32 ).
• IMPORTANT!
Always pull off the adhesive strip (57) from top
to bottom ( Fig. 33, left ), so that no gaps can
arise between the cassettes.
• Insert a filled magazine (54) into the printer as
shown ( Fig. 33 , center picture) and insert it into
the holder at the slot.
• Tilt the magazine backwards as far as it will
go, then firmly push the magazine downwards.
Guide rail (58) must lock into holder (59).
• Keep following this procedure until the printer
is completely filled with magazines; observe
the correct sequence while doing so.
Fig. 33
58 59
57
4. Instrument Setup
Filling and inserting the magazines (continued)
54
Depending on the type of cassettes,
each magazine holds up to 80 cas-
settes.
If cassette sizes other than those spec-
ified in the table on page 31 are to be
used, use trial and error to find out
which insert is required in the maga-
zine.
CAUTION, important note!
Only the cassette sizes listed in the
table on page 31 have been tested with
the Leica IP C.
Leica does not guarantee that cassette
types other than those tested can be
processed in the instrument.