Leica Biosystems IPC - Manual (Page 40)

38 Instructions for Use V 1.9 RevD – 05/2013
Starting installation:
1. Open the printer folder:
START --> SETTINGS --> PRINTERS
2. Double-click the ADD PRINTER icon. the ADD PRINTER WIZARD, which
guides you through the rest of the installation, is started.
Add printer wizard
1. The printer is controlled by the computer to which it is connected; there-
fore, MY COMPUTER must be selected.
2. Insert the correct information—according to your current system—in
the dialog boxes that follow. Click NEXT to move on to the next dialog
box.
3. In the next dialog box, an available serial interface (COM 1, etc.) must
be selected, as the printer only works with an RS 232 interface. Do not
select a parallel printer port (LPT ...)!
4. Next, select the printer manufacturer and model. Click HAVE DISK...
to open the INSTALL FROM DISK dialog box.
5. Insert the CD containing the printer driver (part of standard delivery) into
the CD-ROM drive and enter the following path in the input field:
X:\IP_Driver\IP_C\English
and click OK to confirm. " X " is to be
replaced by the letter corresponding to the drive containing the CD.
4.10 Installing the printer driver
4. Instrument Setup
This printer driver only runs under the operating systems Microsoft Windows NT 4.0,
Windows 2000 and Windows XP. The description below refers to the installation of the driver
under Windows NT. Any steps that need to be carried out in a different way when installing
under other Windows versions are also explained below.
"Microsoft", "Windows NT", "Windows 2000", "Windows XP" and "Windows 7 (32 bit and 64 bit)" are
registered trademarks of Microsoft Corporation.
You must have administrator rights to be able to install the printer driver.