Lenze E94AxHE Technology Application Electronic gearbox - Manual (Page 25)

EDS94TA10030xxxx EN 1.2 - 11/2009
L
25
9400 Technology applications | Electronic gearbox
Short setup
Step 1: Creating a project
4.3 Step 1: Creating a project

Tip!
Since the components of the master and slave axis are identical in the application
example, you can use the copy&paste function to create the project in the
»Engineer«:
• In the first step, only insert the master drive axis.
• Then, parameterise the technology application "Electronic gearbox" for the
master drive.
• When the required settings have been made, copy the master axis in the project
view, paste it, and rename it.
1. Start »Engineer«.
2. Go to Start-up wizard and select the option "New project (empty)" and enter a name for
the project in a next step.
3. Insert the axis for the master drive.
– Add the corresponding components to the axis (controller, motor, digital frequency
extension module).
– Select the application "Electronic gearbox" for the controller. (Do not select
"Electronic gearbox MotionBus" because the digital frequency extension module is
only supported by the variant without MotionBus.)
– Example project view in the »Engineer«: