MTS Acumen User Manual
Page 40
Description
Controls
Section
4 Scroll. Scrolls down the text display. Selection
cycles to the top when the bottom line is
highlighted and you press the button.
5 Enter. Executes the highlighted command in
the display (for example, selecting Low and
pressing Enter would apply low power).
Indicators and controls related to actuator
power and control
B
1 Controller interlock indicator. When
illuminated, an interlock has occurred. On the
MTS TestSuite software, hover your cursor over
the red system error icon in the Status panel for
the cause of the interlock, or click the open
window icon to view all status indicators.
2 Door Open (only active with optional test area
enclosure). When illuminated, the door to the
test area enclosure is open, High-Power Prohibit
is activated, and the system is in High-Speed
Prohibit mode (see
(p. 18)). When the door is closed, the door
indicator is not visible.
3 High-Power Prohibit indicator. When
illuminated, the machine is in High-Power
Prohibit mode. The machine can be put into
High-Power Prohibit mode by pressing the
High-Power Prohibit button or by opening the
door of the optional test area enclosure.
4 Power Indicator. Two bars = Low Power, Five
bars = High Power.
5 Button to reset interlocks and override them
temporarily (30 seconds). Each time you press
the button, another 30 seconds is added to the
override time which gets shown on the display
(see A1). If you reset an interlock from the
frame-mounted control, MTS recommends that
you press Enter to cancel the override.
Important:
When you press this button, all limits are
overridden.
6 High-Speed Prohibit button. Press to toggle
High-Power Prohibit mode (see
(p. 18)) on and off. High-Power
Prohibit mode prevents the actuator from going
into the Power High state.
40 | MTS Acumen
™
System Introduction