MTS Acumen - Manual (Page 60)

Situational Awareness Panel
Description Icon Item
Thumb control for setting a fixture protection limit. When you move
the thumb control, the selected value appears. For more information,
see
Setting Fixture Limits (p. 156).
1
Important: When setting limits, be sure to enable them! Blue
indicates an enabled limit while gray indicates a disabled limit.
Right click on the thumb control to change the status of a limit.
Indicates tension. Observe the virtual load frame image for the + or
- sign to determine if tension was set to positive or negative during
the Install Fixturing phase. 2
Indicates compression. Observe the virtual load frame image for the
+ or - sign to determine if tension was set to positive or negative during
the Install Fixturing phase. 3
Magnifying icon, which magnifies the actuator rod and thumb controls.
For more information, see
Magnifying the controls in this section.
4
60 | MTS Acumen ™
System Introduction