MTS Acumen - Manual (Page 57)

Test Run Status Panel
Description Item
Stop the procedure. This button becomes active when a test is in the Initialized or
Stopped status and a test run is selected. The button is inactive when the status is Stop
Running or Completed. The button is inactive when a test run is not selected. To
make the button active when a test is running, click Stop or Stop At.
When you click the Stop the Procedure button, the arrow changes color. The
application panel and test panel buttons become unavailable. The Results tab
appears. The status is Stopped.
Start the procedure. This button becomes active when you click the Stop button. The
status is Stopped. Start
When you click the Start button, a message prompts you to click Yes to save the
project and continue the test or to click No. If you click Yes, the button changes color.
The status is Stopped. The Run and Stop buttons become active.
If you click No, the test status remains unchanged and the Start button remains
active.
Initialized—The test procedure is loaded. The project must be saved for the test to
continue. Test Run Status
Running—The test is in progress. The Running Time box shows the current elapsed
run time. The time that elapses while the test run is held or stopped is not included.
Holding—The test run is held at the end of the current cycle. The Running Time
box does not change until the test run is restarted. The test resumes at the start of
the next segment.
Stopped—The test run is stopped in place. If the test was in a cycle, the cycle
completes before the test stops. The Running Time box does not change until the
test run is restarted. The test restarts at the beginning of the current cycle. The test
run can be manually unloaded while in this state.
Completed—The test run is complete and is automatically unloaded.
MTS Acumen ™ | 57
System Introduction