MTS Acumen - Manual (Page 52)

Corrective Action Error Status Indicator Item
The fans to cool the motor increase in speed
with increasing temperature and will become
louder. This is normal system operation, and
it is not necessary to shut down the system.
Reducing the frequency and/or force output
of the system will allow the motor to cool
down.
Ambient air temperature may be too high.
Check that air intake and exhaust vents on
the MTS Acumen frame are clean and not
obstructed.
Refer to the message log for details. Status indicator to cover
less common fault Other 12
conditions. Also lights
whenever the
Emergency Stop is set.
See individual status information. Programs are not
allowed to run in this
state. Gate Interlock 13
Press Interlock Reset to clear this fault.
Close the door to the test area enclosure. The door to the test area
enclosure is open. The Safety enclosure
status 14
system will not allow
high power.
Press the High-Power Prohibit button on the
frame-mounted control to toggle its state. The High-Power Prohibit
button on the
frame-mounted control 'High-power
prohibit' button
status 15
is active. The system will
not allow High Power.
Lock the crossheads. One or both sides of the
crosshead is unlocked. Crosshead lock
status 16
Verify that the left crosshead lock handle is
in the fully locked position and the left The left side of
crosshead is not fully
locked. Left crosshead
lock status 17
crosshead lock icon on the frame-mounted
control is illuminated.
Verify that the right crosshead lock handle
is in the fully locked position and the right The right side of
crosshead is not fully
locked. Right crosshead
lock status 18
crosshead lock icon on the frame-mounted
control is illuminated.
Verify that the Frame Status cable is
connected securely and that the frame is
powered on. Communication to the
frame has been lost. Watch Dog 19
52 | MTS Acumen ™
System Introduction