MTS Acumen - Manual (Page 62)

Note:
Limit detectors are sensors within the system that detect when the minimum and maximum limit
values you select have been triggered. To enable or disable the limit detectors for a particular limit,
right-click the thumb control and select the On or Off radio button.
Axial Displacement Magnify Panel
Moving the Actuator Using Manual Controls
To move the actuator using manual controls, click the Control icon in the lower right corner of the diagram.
This panel also allows you to modify the Manual Command Control Settings. To open the Manual Command
Control Settings window, click the cog wheel icon next to the Command box. The green lines in the
following figure show the Manual Command Control Settings panel opening after clicking the cog wheel.
62 | MTS Acumen ™
System Introduction