SATEC PM180 Operation Manual - Manual (Page 31)

‎Chapter 3 Using the RDM Data Display
PM180 Substation Automation Unit 29
Page Label Parameter Units LED
14 Ph.L3
Power factor L3 PF
kW L3 kW/MW
15 kVA L3 kVA/MVA
Ph.L3
kvar L3 kvar/Mvar
16 Fundamental V1/V12 V1/V1-2 - kV1/kV1-2
Fundamental V2/V23 V2/V2-3 - kV2/kV2-3
1H Fundamental V3/V31 V3/V3-1 - kV3/kV3-1
17 Fundamental I1 A1
Fundamental I2 A2
1H Fundamental I3 A3
18 01H
Fundamental total power factor PF
Fundamental total kW kW/MW
Phase Powers Readings
In addition to three-phase power, the RDM shows per-phase power readings in
configurations with a neutral. By default, they are disabled. See
Configuring the RDM
on how to enable per-phase power readings in your RDM.
Fundamental Harmonic Readings
The RDM shows volts, currents, total power factor and active power for the
fundamental harmonic if they are enabled through the Display Setup Menu (see
Configuring the RDM ).
Min/Max and Max. Demand Display
Press the MIN/MAX key. The MIN/MAX LED is illuminated. Use the UP/DOWN arrow
keys to scroll through Min/Max and Max. Demand measurements.
The following table shows Min/Max display pages. Note that volts readings are
phase-to-neutral in 4LN3 and 3LN3 wiring modes, and phase-to-phase in all other
modes.
Page Label Parameter Units LED
1 Minimum V1/V12 V1/V1-2 - kV1/kV1-2
Minimum V2/V23 V2/V2-3 - kV2/kV2-3
Lo Minimum V3/V31 V3/V3-1 - kV3/kV3-1
2 Minimum current I1 A1
Minimum current I2 A2
Lo Minimum current I3 A3
3 Minimum total kVA kVA/MVA
Minimum total power factor PF
Lo Minimum total kW kW/MW
4 Minimum neutral current A Neut.
Minimum frequency Hz
Lo Minimum total kvar kvar/Mvar
5 Maximum voltage V1/V12 V1/V1-2 - kV1/kV1-2
Maximum voltage V2/V23 V2/V2-3 - kV2/kV2-3
Hi Maximum voltage V3/V31 V3/V3-1 - kV3/kV3-1
6 Maximum current I1 A1
Maximum current I2 A2
Hi Maximum current I3 A3
7 Maximum total kVA kVA/MVA
Maximum total power factor PF
Hi Maximum total kW kW/MW
8 Maximum neutral current A Neut.
Maximum frequency Hz