Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 8)

8 PowerMonitor 1000 Unit
Rockwell Automation Publication 1408-IN001E-EN-P - September 2013
Mount the PowerMonitor 1000 Unit
The power monitor can be mounted on a panel or a DIN rail.
Panel Mount
Follow these steps to mount the unit on a panel or any flat surface.
1. Extend the top and bottom DIN rail clips to the panel mount position.
2. Insert a small screwdriver under the spring pin to move the clip, lift it, and pull the clip
forward until it extends approximately 6 mm (0.25 in.) from the enclosure.
3. Release the pin and lock the clip in the panel mount position.
4. Mount the unit by using three M4 or #8 machine screws.
DIN Rail Mount
You can mount the unit on standard 35 x 7.5 mm (EN 50 022 – 35 x 7.7) DIN rail. To mount on
a DIN rail, leave the mounting clips retracted so the mounting holes are hidden behind the unit.
Install
Follow these steps to mount the unit on a DIN rail.
1. Tilt the bottom of the unit slightly away from the rail until the notches grab onto the top
flange of the DIN rail.
2. Push the bottom of the enclosure forward towards the DIN rail.
The spring-loaded clip snaps onto the bottom of the rail and holds the unit firmly in
place.