Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 13)

Chapter
2
Publication 1203–5.9 –– October 1996
Installing the SLC to SCANport
Module
Chapter 2 covers the following information:
•
what you need to do before you install the SLC to SCANport
module
•
how to install the SLC to SCANport module
•
how to remove the SLC to SCANport module
Important: You cannot place an SLC rack unit containing an SLC
to SCANport module in an enclosure that is less than
200 mm (8 in) deep.
Before you install your SLC to SCANport module, you need to:
•
Determine the length of your SCANport cable(s).
•
Determine the placement of your SCANport cables.
•
Locate the DIP switch on your SLC to SCANport module.
Chapter Objectives
Before You Install the
Module