Rockwell Automation 1203-SM1 SLC to SCANport Communication Module User Manual
Page 21
3–3
Using Basic Mode
Publication 1203–5.9 –– October 1996
7. Move the cursor to the slot containing the SLC to SCANport
module.
8. Press F5 to modify the slot. The screen shown in Figure 3.3 is
displayed.
Figure 3.3
Prompt to Enter the Module ID Code
9. Enter the module ID code. For basic mode, the module ID code
is 3516.
10.Press the Enter key.
When you have entered the module ID code, you are returned to the
screen shown in Figure 3.2 with the selected module now shown. If
you press F9, the screen shown in Figure 3.4 shows the
configuration information for the SLC to SCANport module. You
should not need to change this information for basic mode.
Figure 3.4
Specialty Module Configuration Screen
Figure 3.5 shows an example of a completed I/O configuration.