Rockwell Automation 1746-NR4 SLC RTD/Resistance Input Module User Manual - Manual (Page 24)

Publication 1746-UM008B-EN-P - December 2006
24 Quick Start Guide
Procedures Follow these procedures to get your RTD module installed and ready
to use.
Unpack the Module
Unpack the module making sure that the contents include:
• RTD module, catalog number 1746-NR4.
• Installation instructions, publication 1746-IN012.
If the contents are incomplete contact your Allen-Bradley
representative for assistance.
Determine Power Requirements
Review the requirements of your system to see that your chassis
supports placement of the RTD module.
• The fixed, 2-slot chassis supports two RTD modules.
If combining an RTD module with a different module, refer to
the module compatibility table found in chapter 3.
• For modular style systems, calculate the total load on the system
power supply using the procedure described in the SLC 500
Modular Style User Manual, publication 1747-UM011.
For more information refer to chapter 3, Install and Wire and
Appendix A, Specifications.