Use the rockwell bootp/dhcp utility, Use the rockwell bootp/ dhcp utility – Rockwell Automation 1738-AENT, Series B ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 28
Advertising
18
Rockwell Automation Publication 1738-UM005A-EN-P - July 2013
Chapter 3 Configure the Adapter with RSLogix5000 software
Use the Rockwell BootP/
DHCP Utility
The Rockwell BootP/DHCP utility is a standalone program that incorporates
the functionality of standard BootP software with a user-friendly graphical
interface. It is located in the
Utils directory on the RSLogix5000 software
installation CD. The adapter must have DHCP enabled (factory default and the
network address switches set to an invalid value) to use the utility.
To configure your adapter using the BootP utility, perform the following steps:
1. Run the BootP software.
In the BOOTP Request History panel you see the hardware addresses of
devices issuing BootP requests.
Advertising