Rockwell Automation 1738-AENT, Series B ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual - Manual (Page 50)

40 Rockwell Automation Publication 1738-UM005A-EN-P - July 2013
Chapter 4 Configure the Adapter for Direct Connection in RSLogix 5000 Software
Add the Analog Current Output Module
1. Highlight the 1738-AENT/B adapter under the I/O Configuration
folder, right-click and select New Module.
The Select Module dialog opens.
2. Select the appropriate Module Type Category Filter (for the example we
selected Analog) and Module Type Vendor (for the example, we selected
Allen-Bradley). Note: to select only one category you will need to unselect
those already selected.
3. From the modules listed select the 1738-OE2CM12 module and click
Create.
IMPORTANT If the 1738-AENT/B chassis base size is exceeded, (that is, you try to
add more modules than you configured) the New Module selection is
dimmed out and disabled. You are not able to add any more
ArmorPoint I/O modules until the 1738-AENT/B chassis base size is
increased.