Add the digital output module, Add the digital output module 50 – Rockwell Automation 1738-AENT, Series B ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 73
Rockwell Automation Publication 1738-UM005A-EN-P - July 2013
63
Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software Chapter 5
6. Change the Connection from Data to Rack Optimization and click OK.
7. In the New Module screen, click OK to accept the configuration.
The digital input module appears in the I/O configuration indented under
the 1738-AENT/B adapter.
Add The Digital Output Module
1. Highlight the 1738-AENT/B adapter under the I/O Configuration
folder, right-click and select New Module.
The Select Module Type dialog opens.
IMPORTANT
If the 1738-AENT/B adapter chassis size is exceeded, (that is, you try
to add more modules than you configured) the New Module selection
is dimmed out and disabled. You are not able to add any more
ArmorPOINT I/O modules until the 1738-AENT/B adapter chassis size
is increased.