Configure the i/o modules – Rockwell Automation 1738-AENT, Series B ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 64
54
Rockwell Automation Publication 1738-UM005A-EN-P - July 2013
Chapter 5 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
Configure the I/O Modules
You now add the ArmorPOINT I/O modules to the controller’s I/O
configuration performing these procedures:
•
Add the local 1756-ENBT module to the I/O configuration.
•
Add the 1738-AENT/B adapter as a child of the 1756-ENBT module on
the Ethernet network.
•
Add the ArmorPOINT I/O modules as children of the 1738-AENT/B
adapter.
Add the Local EtherNet/IP Bridge to the I/O Configuration
1. Right-click the I/O Configuration folder in the project dialog, and select
New Module.
IMPORTANT
Click the Help button on the configuration dialog shown in this
section if you need assistance in selecting and setting the
parameters.