Rockwell Automation 1738-AENT, Series B ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual - Manual (Page 79)

Rockwell Automation Publication 1738-UM005A-EN-P - July 2013 69
Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software Chapter 5
4. Enter values for Name and Slot, noting that we used the following values
Note the module definition properties on the bottom left of the New
Module dialog. You have the option to change these properties by clicking
the Change... button. Some of the properties cannot be modified while
pending edits exist.
5. Select Change...
The Module Definition dialog displays.
6. Change the Connection properties from the default value to Data for
Direct Connection and click OK.
7. In the New Module dialog, click the Connection tab to set the RPI value.
Note that RPI is selectable on the screen because you are adding an analog
module and an RPI value must be assigned for the module.
Name ArmorPoint Analog Current Output
Slot 4