Rockwell Automation 1746-NR8 SLC 500 RTD/Resistance Input Module User Manual - Manual (Page 26)

Publication 1746-UM003A-EN-P
2-6 Installation and Wiring
Removing the Terminal Block
1. 1. 1. 1. Loosen the two terminal block release screws.
2. 2. 2. 2. Grasp the terminal block at the top and bottom and pull outward and
down.
ATTENTION
!!!!
Never install, remove, or wire modules with power applied
to the chassis or devices wired to the module. To avoid
cracking the removable terminal block, alternate the
removal of the slotted terminal block release screws.
Terminal Block
Release Screw
(Requires a 0.100 in
slot screwdriver.)
Maximum Torque = 0.25 Nm (2.25 in-lbs)