Rockwell Automation 1746-NR8 SLC 500 RTD/Resistance Input Module User Manual User Manual
Page 83
Advertising
Publication 1746-UM003A-EN-P
Ladder Programming Examples 5-11
Example
Example
Example
Example - Command the RTD module to perform an autocalibration of
channel 0. The RTD module is in slot 3. This example assumes that the
periodic calibration bit (bit 15) is in the disabled state (set to 1).
Programming to Invoke Autocalibration
ATTENTION
!!!!
Several channel cycles are required to perform an
autocalibration and it is important to remember that
during autocalibration the module is not converting input
data.
] [
I:1
1
B3
0
[OSR]
(U)
O:3.0
15
Channel 0 Flag
(L)
B3
1
B3
1
] [
(L)
O:3.0
15
Channel 0 Flag
(U)
B3
1
Condition for
Autocalibration
Rung 2:0
Rung 2:1
Channel 0 Flag
Advertising