Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual - Manual (Page 107)

Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014 107
Chapter
5
Install and Replace Components
Required Tools You need a #1 and #2 Phillips screwdriver to replace some of the components.
Topic Page
Install or Replace the Logic Module 108
Install or Replace a Communication Module 109
Replace the Display Module 111
Replace the Bezel 112
Replace the Backlight 114
Replace the Battery 117
Install the AC Power Supply Module 119
Remove the Product ID Label 122
Load an SD Card 122
Clean the Display 123
ATTENTION: Prevent Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which can cause internal
damage and affect normal operation.
Follow these guidelines when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• Use a static-safe workstation, if available.
• Store the equipment in appropriate static-safe packaging when not in use.
SHOCK HAZARD: Disconnect power from the terminal before installing or
replacing any components. Failure to disconnect power can result in electrical
shock or damage to the terminal.