Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual - Manual (Page 27)

Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014 27
Install the Terminal Chapter 2
2. Gently push the top of the terminal block to rotate it into place.
The terminal block snaps into place when seated.
1000 Terminals
Follow these steps to remove the terminal block from a 1000 terminal.
1. Loosen the two screws that secure the terminal block.
2. Gently pull the terminal block away from the connector.
Follow these steps to install the terminal block.
1. Reattach the terminal block to the connector until seated.
2. Tighten the two screws that secure the terminal block to a torque of
0.40…0.51 N•m (3.5…4.5 lb•in).
Three-position
AC Terminal Block
Two-position
DC Terminal Block