Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual User Manual
Page 115
Advertising
Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
115
Install and Replace Components
Chapter 5
Follow these steps to replace the backlight.
1. Disconnect power from the terminal.
2. Remove the display module bezel.
3. Remove the four screws that secure the LCD display.
4. Lift the LCD display and detach the display connector from the circuit
board.
5. Detach the backlight connectors from the circuit board.
6. Press the retaining tab that secures the backlight, then pull out the
backlight.
Display
Connector
Backlight
Retaining Tab
Advertising