Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual - Manual (Page 47)

Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014 47
Configuration Mode Chapter 3
Table 23 - Communication Driver Properties
Field Description Valid Values
Serial Properties
Use Auto Config Automatically or manually configures the baud rate, parity, and error checking
parameters. Yes (auto configure)
No (manual configure)
Device The serial device that the terminal is connected to. PLC-5
®
, SLC
™, MicroLogix™, Logix
Platform
Error Check Type of error checking used. Error checking is automatically configured if Use Auto Config
is set to Yes. BCC, CRC
Parity Type of parity used. Parity is automatically configured if Use Auto Config is set to Yes. None, Odd, Even
Baud Rate Data rate at which serial driver communicates. The baud rate is automatically configured
if Use Auto Config is set to Yes. 110, 300, 600, 1200, 4800, 9600,
19200, 38400, 57600, 115200
Stop Bits Number of stop bits used. 1 or 2
Ack/Poll Timeout Ack/Poll timeout value in ms. 20…60,000 ms
Max Retries Number of retries before serial driver fails. 0…10
Station Number Station number based on a specific device. 0…254
COM Port Communication port used on the terminal. 1…4
DH-485 Properties
Jumper ID Identifies the communication card if multiple cards are installed on the terminal. 0…3
Station Number The unique station number of the terminal on the DH-485 network. 0…31 (decimal)
Baud Rate The communication rate of the DH-485 network. 9600
19200
MaxStationNumber The maximum station number on the DH-485 network. The value must be greater than or
equal to the Station Number. 0…31 (decimal)