Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual - Manual (Page 122)

122 Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
Chapter 5 Install and Replace Components
Remove the Product ID Label You can replace the product ID label on the terminal with a custom label.
1. Remove the Allen-Bradley label by using your fingers or a tweezers.
2. Clean area with damp cloth and isopropyl alcohol.
3. Remove adhesive backing of new label and affix to the same location.
Load an SD Card A Secure Digital (SD) card provides extra storage when inserted into the SD card
slot. Supported cards include catalog number 1784-SDx. The SD cards are
hot-swappable; they can be inserted and removed while the terminal is operating.
The SD card slot is accessible from the inside or back of the panel in which the
terminal is installed.
Follow these steps to install an SD card in the card slot.
1. Verify that the SD card is locked or unlocked according to your preference:
• If unlocked, the terminal can write data to or read data from the card.
• If locked, the terminal can only read data from the card.
2. Insert the SD card firmly into the slot until you hear a click.
Press and release the SD card to eject the card from the slot.
ATTENTION: Orient the SD card correctly before inserting into slot.
Forcing the card into the slot can damage the card or the terminal.
Unlocked
Locked