Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual User Manual
Page 116
Advertising
116
Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
Chapter 5
Install and Replace Components
7. Insert the new backlight.
8. Insert the new backlights then secure each with the same screws from the
previous step, and torque to 0.117 N•m (1.04 lb•in).
9. Attach the LCD display connector to the circuit board.
Refer to
step 4
.
10. Attach the backlight connector to the circuit board.
Refer to
step 5
.
11. Secure the LCD display with the four screws.
Tighten the screws and torque to 0.58 N•m (5…7 lb•in).
12. Replace the display module bezel.
Backlight
Advertising