1000 terminals – Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual User Manual
Page 118
118
Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
Chapter 5
Install and Replace Components
3. Lift up on the cover.
4. Remove the battery.
5. Insert the new battery with the positive (+) polarity facing up and press
gently until the battery snaps into place.
6. Close the battery cover and push the end in until you hear a click.
1000 Terminals
Follow these steps to replace the battery.
1. Disconnect power from the terminal.
2. Place the terminal, display side down, on a flat stable surface.
3. If the communication module is attached, remove the four screws that
secure the communication module to the logic module.
4. Loosen the four captive screws that attach the logic module to the display.
CR2032
Communication Module
Display Module
Captive Screw
Screw
Logic Module