Rockwell Automation 1440-TPR06-00RE XM-360 Process Module - Manual (Page 25)

Publication GMSI10-UM006C-EN-P - August 2010
Installing the XM-360 Process Module 17
Connecting Wiring for Your
Module Wiring to the module is made through the terminal base unit on which the
module mounts. The XM-360 is compatible only with the XM-944 terminal
base unit, Cat. No. 1440-TB-E.
Figure 2.7 XM-944 Terminal Base Unit
Terminal Block Assignments
The terminal block assignments and descriptions for the XM-360 module are
shown below.
ATTENTION
The terminal block assignments are different for different
XM modules. The following table applies only to the
XM-360. Refer to the installation instructions for the
specific XM module for its terminal assignments.
WARNING
EXPLOSION HAZARD
Do not disconnect equipment unless power has been
removed or the area is known to be nonhazardous.
Do not disconnect connections to this equipment unless
power has been removed or the area is known to be
nonhazardous. Secure any external connections that mate
to this equipment by using screws, sliding latches, threaded
connectors, or other means provided with this product.
XM-944, Cat. No. 1440-TB-E
Terminal Block Assignments
No. Name Description
0 Chassis Connection to DIN rail ground spring or panel mounting hole
1 Chassis Connection to DIN rail ground spring or panel mounting hole
2 Chassis Connection to DIN rail ground spring or panel mounting hole