Rockwell Automation 1440-TPR06-00RE XM-360 Process Module - Manual (Page 55)

Publication GMSI10-UM006C-EN-P - August 2010
Configuration Parameters 47
Alarm Parameters
Parameter Name Description Values/Comments
Number (XM Serial Configuration
Utility only) Sets the type of measurement and channel that is
associated with the alarm. There are 12 alarms in
the XM-360. Each alarm is associated with a
measurement.
Note: Channel 6 is not available if the Enable
Relay Reset Switch Terminals parameter is
enabled. See page 44.
Options: Channel 1 Value
Channel 2 Value
Channel 3 Value
Channel 4 Value
Channel 5 Value
Channel 6 Value
Channel 1 Rate
Channel 2 Rate
Channel 3 Rate
Channel 4 Rate
Channel 5 Rate
Channel 6 Rate
Channel 1 Difference (Ch1
minus Ch6)
Channel 2 Difference (Ch2
minus Ch1)
Channel 3 Difference (Ch3
minus Ch2)
Channel 4 Difference (Ch4
minus Ch3)
Channel 5 Difference (Ch5
minus Ch4)
Channel 6 Difference (Ch6
minus Ch5)
Name (XM Serial Configuration
Utility only) A descriptive name to identify the alarm in the XM
Serial Configuration Utility. Maximum 18 characters
Enable Enable/disable the selected alarm.
Note: The Alarm Status is set to "Disarm" when the
alarm is disabled.
XM Configuration
Utility EDS File
Check to Enable Enabled
Clear to Disable Disabled