Rockwell Automation 1440-TPR06-00RE XM-360 Process Module - Manual (Page 32)

Publication GMSI10-UM006C-EN-P - August 2010
24 Installing the XM-360 Process Module
A single switch contact can also be shared by multiple XM-360 modules wired
in series as shown in Figure 2.12. When multiple modules are wired to a single
switch, only one 4-20mA output channel is necessary to supply all the
modules.
Figure 2.12 Typical Multiple XM Modules Remote Relay Reset Signal Connection
ATTENTION
The relay reset connections may be different for different
XM modules. Figure 2.12 applies only to the XM-360
module. Refer to the installation instructions for the
module for its terminal assignments.
IMPORTANT
The XM-360/361/362 relay reset signal is not compatible
with other XM module’s relay reset input. Use of a single
switch requires a multi-pole switch. Refer to the XM
Module User Manual for more information about the other
XM modules.
TIP
Up to 24 XM-360 modules can be wired in series in a single
loop.