Rockwell Automation 1440-TPR06-00RE XM-360 Process Module - Manual (Page 43)

Publication GMSI10-UM006C-EN-P - August 2010
Installing the XM-360 Process Module 35
Figure 2.30 Non-loop Powered 4-20mA Input to Channel 6 Wiring
PC Serial Port Connection
The XM-360 includes a serial connection that allows you to connect a PC to it
and configure the module’s parameters. The connection is through a
mini-connector that is located on top of the XM-360, as shown below.
Figure 2.31 Mini-Connector
A special cable (Cat. No. 1440-SCDB9FXM2) is required for this serial
connection. The connector that inserts into the PC is a DB-9 female
TYPICAL WIRING FOR NON-LOOP POWERED 4-20mA INPUT
TO XM-360 PROCESS MODULE CHANNEL 6
30
29 4-20mA
Transmitter - +
13
14
43
RED
BLK
RED
BLK
SHIELD
PROCESS
1440-TPR06-00RE
mini-connector