Rockwell Automation Liqui-Flo AC Power Modules - Manual (Page 7)

Contents V
List of Figures
Figure 2.1 – Identifying the Drive Model Number ..................................................... 2-1
Figure 2.2 – B-Frame LiquiFlo Drive Component Locations..................................... 2-3
Figure 2.3 – C-Frame LiquiFlo Drive Component Locations .................................... 2-5
Figure 2.4 – D-Frame LiquiFlo Drive Component Locations .................................... 2-7
Figure 2.5 – LiquiFlo Regulator Board Component Locations.................................. 2-9
Figure 2.6 – Jumper J4 Settings for Analog Input Speed Reference ..................... 2-11
Figure 2.7 – Jumper J17 Settings for Analog Outputs............................................ 2-12
Figure 2.8 – Typical Regulator Board Terminal Strip Connections......................... 2-13
Figure 2.9 – Keypad/Display................................................................................... 2-14
Figure 2.10 – Terminal Connections on the RMI Board ......................................... 2-16
Figure 3.1 – B-Frame Drive Dimensions .................................................................. 3-3
Figure 3.2 – C-Frame Drive Dimensions .................................................................. 3-4
Figure 3.3 – D-Frame Drive Dimensions .................................................................. 3-5
Figure 4.1 – Wire Routing Locations for B-Frame LiquiFlo Drives ........................... 4-3
Figure 4.2 – Wire Routing Locations for C-Frame LiquiFlo Drives ........................... 4-4
Figure 4.3 – Wire Routing Locations for D-Frame LiquiFlo Drives ........................... 4-5
Figure 4.4 – DC Bus Reactor Cooling Fan Mounting Location................................. 4-6
Figure 4.5 – Coolant Connector Locations for B-Frame LiquiFlo Drives .................. 4-8
Figure 4.6 – Coolant Connector Locations for C-Frame LiquiFlo Drives .................. 4-9
Figure 4.7 – Coolant Connector Locations for D-Frame LiquiFlo Drives .................. 4-9
Figure 5.1 – Typical AC Input/Output Electrical Connections
(6-Pulse Rectifier, All Frames)................................................................ 5-2
Figure 5.2 – Typical AC Input/Output Electrical Connections
(12-Pulse Rectifier, B- and C-Frames Only) ........................................... 5-3
Figure 7.1 – Two-Wire Start/Stop Sample Control Wiring ........................................ 7-5
Figure 7.2 – Three-Wire Start/Stop Sample Control Wiring...................................... 7-6
Figure 7.3 – Encoder Wiring Connections ................................................................ 7-9
Figure 7.4 – Terminal Connections on the RMI Board ........................................... 7-19
Figure 9.1 – DC Bus Voltage Terminals (B-Frame Drives)....................................... 9-2
Figure 9.2 – DC Bus Voltage Terminals (C-Frame Drives) ...................................... 9-3
Figure 9.3 – DC Bus Voltage Terminals (D-Frame Drives) ...................................... 9-4