Metrohm 881 Compact IC pro – Anion – MCS - Manual (Page 20)

3.1 About this chapter
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
10 ￭￭￭￭￭￭￭￭
881 Compact IC pro – Anion – MCS
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview.
￭ a brief set of instructions for the initial installation of the 881 Compact
IC pro – Anion – MCS. At each step you will find cross-references to
more detailed installation instructions for individual components,
should you require such aids.
￭ an installation diagram (see Chapter 3.3, page 14), showing a com-
pletely installed 881 Compact IC pro – Anion – MCS.
￭ several chapters with detailed installation instructions for all compo-
nents, including those that are already installed at the time the instru-
ment is delivered.
3.2 Initial installation
Note
A number of the capillaries is already connected at the time the instru-
ment is delivered.
The following work steps must still be carried out:
881 Compact IC proInstalling – Anion – MCS
1 Setting up the instrument
(see Chapter 3.4, page 17).
2 Installations on the rear of the instrument
￭ Place the detector in the instrument and connect it (see manual
of the detector).
￭ Remove all of the transport locking screws with the 4 mm hexa-
gon key (6.2621.030) and keep them in a safe place.
￭ Connect the leak sensor (see Chapter 3.6.2, page 20).
￭ Connect the drainage tubings (see Chapter 3.6.3, page 21).