ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 114)

6-8 ADS RainAlert II Manual
Checking the Tipping Bucket
Perform the following tipping bucket inspections and service during
regular site visits:
 Inspect the tipping bucket to ensure it is still tightly secured to
the base plate or sun shield and free from damage.
 Remove and clean out the screen and funnel. Verify that the
opening to the funnel is clear and that the tipping mechanism is
operational.
 Clean the tipping bucket regularly with a soft bristle brush and
paper towels. However, do not use detergent!
 Calibrate the tipping bucket to ensure the accuracy of the
tipping mechanism. Refer to Calibrating the Tipping Bucket in
Chapter 3, Hardware Installation, for detailed instructions on
performing calibrations.
 Confirm that the cable connecting the tipping bucket to the
monitor is securely fastened and free of debris, cuts, and breaks
that may affect performance. Replace a damaged cable, when
necessary.
Checking Communication Devices
Inspect the following communication devices during site visits:
 Antenna Cable Check the internal or external antenna cable
for damage, kinks, or breaks. Make sure the connector between
the (external) antenna cable and the monitor is dry and sealed
with rubber stretch tape.
 Lightning Protection Module Check the lightning
protection module for lightning strikes (visible arcing),
damaged or poor connections, or corrosion. Replace a burned
out module, and repair any bad or corroded connections in the
wiring.