ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 43)

4-2 ADS RainAlert II Manual
Setting Up Wireless Communication
Note: ADS wireless communication products use static
IP address network services provided by AT&T.
Therefore, any installation location designated for wireless
communication must have access to AT&T 850 or 1900
MHz service. Each wireless device must be fitted with a
SIM (Subscriber Identity Module) card that is provisioned
by AT&T with specific account and network information
for use with ADS software. Refer to Installing the SIM
Card on page 4-9 for more information.
The RainAlert II monitor equipped for wireless communication
(ADS p/n 6000-RAW) includes an integrated, internal antenna.
This configuration should function well under most circumstances
and requires no additional setup. However, if the internal antenna
does not provide an adequate signal strength or consistency, ADS
offers two additional options for implementing wireless
communication using external antennas:
 Miniwing or Slim Antenna These antennas mount to poles
or other structures.
Miniwing antenna