ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 77)

5-10 ADS RainAlert II Manual
Edit the notification device to setup alarm and/or event notification
the following way, and select OK when complete:
 Alarm Enable Select this checkbox to activate the options for
configuring alarm notification to an IntelliServe system,
cellular phone, and/or email address.
 IntelliServe Recipient Enter the IP address for the
IntelliServe system you want the RainAlert II monitor to notify
under alarm conditions.
 Port This non-editable field represents the number of the port
through which wireless communication will occur (when
applicable). The current default and only applicable port is
2100.
 Max Retries Enter the number of times within a sample
interval you would like the RainAlert II monitor to attempt to
establish communication following an event.
 Diagnostics Enable Select this checkbox to enable the
RainAlert II monitor to send out event notification to a cellular
phone or email address.
 Check In Enable Select this checkbox to ensure the
RainAlert II monitor checks in daily through an email or text
message. The daily check-in provides the monitor name, date
and time, and battery voltage.
 Check In Hour Select the time at which you want the
monitor to check in from the drop-down list.
 Message Select this button to display the Edit Alarm
Recipients dialog for entering alarm/event recipient email
addresses and cellular phone numbers.
 Edit Alarm Recipients Enter the email address or cellular
phone number and select the corresponding communication
method for up to three recipients. To receive text messages,
enter both the area code and the phone number for the cellular
phone. Following is an example of the format to use for an
SMS number: 2561234567.
Note: Text messages cannot be sent to land-line numbers.